![]() ![]() All BFD packets exceeding the maximum hop count are dropped.īecause multihop BFD sessions can take arbitrary paths, demultiplex the initial BFD packet based on the source/destination IP address pair. To avoid spoofing with multihop paths, configure the maximum hop count ( max_hop_cnt ) for each peer, which limits the number of hops for a BFD session. Here are some best practices for using multihop paths: Any change to the timer values takes effect only when the session goes down and comes back up.īFD multihop sessions are built over arbitrary paths between two systems, which results in some complexity that does not exist for single hop sessions. Dynamic BFD timer negotiation on an existing session.Resource Diagnostics Using cl-resource-query.Using Nutanix Prism as a Monitoring Tool.Simple Network Management Protocol - SNMP. ![]() Monitoring System Statistics and Network Traffic with sFlow.Using NCLU to Troubleshoot Your Network Configuration.Monitoring Interfaces and Transceivers Using ethtool.Understanding the cl-support Output File.Network Switch Port LED and Status LED Guidelines.Unequal Cost Multipath with BGP Link Bandwidth.Equal Cost Multipath Load Sharing - Hardware ECMP.Bidirectional Forwarding Detection - BFD.Hybrid Cloud Connectivity with QinQ and VXLANs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |